Publicité
the remote control if the state of charge of the remote
control battery is too low.
The operation time for fully charged remote control
battery is approximately 12 hours. Cold weather can
decrease the operation time.
Charge the remote control battery each 6 months to
keep the quality of the battery.
Battery charger
The indicator for the battery status is 2 LEDs on the
battery charger: Battery Power LED (red) and Battery
Status LED (green).
Power
Status
Indication
LED
LED
Red
OFF
The charger is ON. No battery in the
light
charger.
Red
Green
The charger is ON. The battery is
light
light
fully charged.
Red
Green
The charger is ON. The battery
light
light
charges.
flash
Red
OFF
Error on the battery charger, or tem-
light
perature out of the charging span.
flash
To remove and install the remote control battery in the
remote control
1. Turn the remote control to get access to the rear
side where the battery is.
2. Remove or install the remote control battery.
2092 - 003 - 08.08.2024
To charge the remote control battery with the battery
charger
The charging time for an empty remote control battery
is approximately 3 hours with the battery charger. When
you charge the remote control battery, the temperature
must be between 10°C/50°F and 45°C/113°F.
1. Remove the empty remote control battery from the
remote control. Refer to
remote control battery in the remote control on page
41 .
2. Connect the correct socket plug to the battery
charger. The charger comes with different socket
Remote control overview on page 7 .
plugs. Refer to
3. Connect the battery charger to a power outlet. The
power indicator (A) for the battery becomes red.
Battery charger on page 41 .
Refer to
4. Connect the remote control battery to the battery
charger. Make sure that the arrows (B) on the
remote control battery and the battery charger align.
The indicator (C) for the battery status on the battery
charger flashes green when the remote control
battery charges.
5. When the remote control battery is fully charged,
the indicator becomes green. Remove the remote
control battery from the battery charger.
6. Disconnect the battery charger from the power
outlet.
To remove and install the
B
A
C
41
Publicité
