Carina Classic II Manuel D'instruction page 19

8. Always use the proper stitch plate. The wrong plate can cause needle breakage.
9. Do not use bent needles.
10. Do not pull or push the fabric while sewing. This can result in needle breakage.
11. Switch the machine off ("O") when making any adjustments in the needle area, such as threading or changing the
needle, threading the bobbin, or changing the presser foot, and the like.
12. Always unplug the machine when performing cleaning or maintenance work such as replacing the sewing light or
when making any other user maintenance adjustments mentioned in the instruction manual (disconnect the power
plug). Cleaning and maintenance work must not be carried out by children without supervision.
13. Never drop or insert any object into any openings.
14. Use this machine only in dry and protected areas. Never operate the machine in a damp or wet environment.
15. Do not operate the machine where aerosol spray products are being used or where oxygen is being administered.
16. To disconnect, turn the power switch to ("O")(off), then remove the plug from the outlet. Do not unplug by pulling the
cord, instead grasp the plug to pull it from the outlet.
17. If the supply cord of the foot control is damaged, the foot control must be replaced by manufacturer or service
support.
18. Never place anything on the foot control.
19. The machine may only be used in combination with a foot control of the type KD-1902, FC-1902 (110-120V area) /
KD-2902, FC-2902A, FC-2902C, FC-2902D (220-240V area) / 4C-316B (110-125V area) / 4C-316C (127V area) / 4C-
326C (220V area) / 4C-326G (230V area) / 4C-336G (220-240V area).
20. The sound pressure level during normal operation is lower than 75dB(A).
21. This machine is provided with double insulation (except U.S.A/Canada). Use only identical replacement parts. See
instructions for Servicing of double-insulated products.
SERVICING OF DOUBLEINSULATED PRODUCTS
In a double-insulated product, two systems of insulation are provided instead of grounding. No grounding means is
provided on a double-insulated product nor should a means for grounding be added to the product. Servicing a
doubleinsulated product requires extreme care and knowledge of the system and should only be done by qualified.
18