Fill-ins
> aero
|
ame
|
Н
> Ba > a) > ox]
Fill-Ins are short patterns (1 bar) that can be used at the end
of a phrase (e.g. the first verse or chorus) or simply to add
some variation. Fill-Ins are played only once.
Even though there is only one {FILL] button, there are, in fact
two Fill-Ins: Fill-In To Original and Fill-In To Variation. The
function of the ron Mp
depends on whether the display
currently reads
ог PRGA! See also the table above.
If the Variation Division is currently selected, pressing [FILL]
will start the Fill-In To Original pattern and then proceed
with the Original pattern.
If the Arranger is stopped when you press the [FILL] button,
starting the Arranger will start playback of the Fill-In that
leads to the currently selected Division.
Example—if the display shows [amanan] pressing [FILL] and
then starting the Arranger will launch the Fill-In To Variation
pattern.
Fill-Ins last one bar, yet their length also depends on when
you press this button, When pressed in the first half of a bar,
the Fill starts rights away and lasts until the end of the current
bar. Otherwise, the Fill starts on the first beat of the next bar
and lasts an entire bar.
Ending
The Ending Division plays a suitable closing section for the
currently selected Masic Style. Again, the length of the Ending
patterns varies between 2 and 8 bars, Just like Intros, Ending
patterns may contain chord changes, so that it is probably
wiser not to play any chords while the Ending is being played.
Press the [ENDING] button during Arranger playback to
cause the Arranger to play the Ending pattern of the currently
selected Music Style. The Ending starts at the beginning of
the next bar. When it is finished, the Arranger stops.
Fill-Ins
Division choisie | Appuyez 1 Fill sélectionné |
Les Fili-Ins sont de brefs motifs (1 mesure) pouvant servir à
clóturer une phrase (le premier couplet ou le refrain, par
exemple) ou à ajouter une petite variation. Les Fill-Ins ne
sont joués qu'une fois.
ision suivante
Bien qu'il n'y ait qu'un seul bouton [FILL], il y a en fait deux
Fill-Ins: Fill-In To Original et Fill-In To Variation. La fonction
[ыш
[E
dépend donc de la Division choisie:
ou (опена - Voyez aussi le tableau ci-dessus,
Si la Division Variation est sélectionnée, une pression sur
[FILL] lance le motif Fill-In To Original et enchaîne avec le
motif Original.
Si l'Arranger est arrété lorsque vous appuyez sur le
bouton[FILL], le démarrage de l'Arranger produira le Fill-In
qui mène à la Division actuellement sélectionnée.
Exemple—Si l'écran affiche [pawanan], une pression sur [FILL]
suivie du démarrage де l'Arranger lance le motif Fill-In To
Variation.
Les Fill-Ins durent une mesure; cependant, leur longueur
dépend aussi du moment ой vous actionnez ce bouton. Si
vous appuyez durant la premiere moitié d'une mesure, le Fill
débute immédiatement et dure jusqu'à la fin de la mesure en
cours. Sinon, le Fill commence à la mesure suivante et dure
une mesure,
Ending
La Division Ending joue un final approprié pour le style
musical sélectionné. Une fois de plus, la longueur des motifs
Ending varie entre 2 et 8 mesures. A l'instar des introduc-
tions, les motifs Ending peuvent contenir des changements
d'accords. 11 vaut donc mieux éviter de jouer des accords
durant le final.
Appuyez sur le bouton [ENDING] durant la reproduction de
l'Arranger pour lancer le motif Ending du style musical sélec-
tionné. Le final commence au début de la mesure suivante.
Lorsqu'il est terminé, l'Arranger s'arrête.