2.12 STANDS
2.12.1 CENTRE STAND
•
The centre stand position is not electronically controlled; therefore you
can turn the engine on while the vehicle is parked. To place the scooter
on the stand, push pin A and raise the vehicle using the grab rail on the
rear side of the saddle.
2.12.2 SIDE STAND
•
It is on the left side of the vehicle (B – Fig. 22); it is controlled by a
microswitch that does not allow the engine to be started if the stand is
not properly closed.
Do not remove nor tamper with this safety device.
WARNING: in any case, visually check that the stand is closed and its
respective retaining spring is in good working order before start-
ing to ride.
• We advise you to regularly check the retaining system of
both stands. This system is composed of tension springs.
• Always make sure that both stands are on firm and level
ground. Soft soil, gravel, as well as asphalt which has
softened due to heat, etc. may cause the parked motorcy-
cle to fall.
NOTE Do not sit on the scooter while it is resting on one of the
two stands.
All manuals and user guides at all-guides.com
B
Fig. 22
EN
A
23