Catheter Removal - MedComp ARCH-FLO Instructions D'utilisation

Cathéter périphérique
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
Dressing Changes - A dressing should cover the insertion site
at all times. The dressing should be changed per institutional
policy or any time the dressing becomes soiled, wet, or non-
occlusive.
Note: During all dressing changes the external length of the catheter
should be assessed to determine if catheter migration has occurred.
Flushing and Locking - Flush and lock catheter according to
your institutional policy.
The catheter should be flushed with normal saline prior to drug
administration to remove locking solution.
After drug administration lumen should be flushed again with
normal saline and then locked to maintain patency.
Injection Caps - Injection cap(s) or needleless access port(s) should
be changed per institutional policy. If using the supplied needleless
access port(s), do not exceed 100 actuations.
Occluded/Partially Occluded Catheter-If resistance is
encountered to aspirating or flushing, the lumen may be
partially or completely occluded.
Warning: Do not flush against resistance.
If the lumen will neither aspirate nor flush, and it has been
determined that the catheter is occluded with blood, follow
institutional declotting procedure.
Infection:
Caution: Due to risk of exposure to HIV or other blood borne
pathogens, health care professionals should always use Universal
Blood and Body Fluid Precautions in the care of all patients.
Sterile technique should always be strictly adhered to.
Clinically recognized infection should be treated promptly per
institutional policy.
Warning: Only a clinician familiar with the appropriate techniques
should attempt the following procedures.
Caution: Always review facility protocol, potential complications
and their treatment, warnings, and precautions prior to catheter
removal.
1.
Wash hands, gather equipment.
2.
Remove old dressing and inspect insertion site for redness,
tenderness, and drainage.
3.
Grasp catheter near insertion site and using a slow steady
motion, remove catheter from vein.
4.
If resistance is felt - STOP. Retape the catheter and apply a
warm compress to the extremity for 20-30 minutes.
5.
Resume removal procedure. If catheter remains "stuck" follow
institutional policy for further intervention.
6.
Apply pressure, if necessary, until bleeding stops and dress site
following institutional policy.
Note: Inspect catheter and measure length. It must be equal
baseline measurement taken when the catheter was inserted.
Catheter Size
4F X 10CM SINGLE ARCH-FLO™
CT MIDLINE
CATHETER MAINTENANCE
CATHETER PERFORMANCE

CATHETER REMOVAL

Arch-Flo™ CT Midline
Gravity Flow
56 ml/min
-6-
Full Length
Maximum Indicated Power
Priming Volume
0.36cc
Injection Flow Rate
5cc/sec

Publicité

Table des Matières
loading

Table des Matières