Corghi HD 700 Manuel D'utilisation page 38

INTRODUCTION
The purpose of this manual is to provide the
owner and operator of this machine with a set
of practical and safe instructions for the use and
maintenance of the wheel aligner.
If these instructions are carefully followed, the
machine will give you the efficient and long-
lasting service that has always characterised
our products, thus making your work consider-
ably easier.
The following paragraphs define the levels of
danger regarding the machine, associated with
the CAUTION captions found in this manual:
DANGER
Refers to immediate danger with the risk of
serious injury or death.
ATTENTION
Dangers or unsafe procedures that can cause
serious injury or death.
CAUTION
Dangers or unsafe procedures that can cause
minor injuries or damage to property.
Read these instructions carefully before powering
up the machine. Keep this manual and all illustra-
tive material supplied with the machine in a folder
near the tyre changer, where it is readily accessible
for consultation by the machine operator.
The technical documentation supplied is consid-
ered an integral part of the machine, and must
always accompany the equipment if it is sold or
transferred to a new owner.
The manual is only to be considered valid for
the machine of the model and serial number
indicated on the nameplate applied to it.
ATTENTION
Comply with the contents of this manual: any
uses of the machine that are not specifically
described are under the full responsibility of
the operator.
38
Note
Some of the illustrations in this manual have
been taken from photographs of prototypes; the
standard production model may differ slightly
in certain respects.
These instructions are for the attention of persons
with basic mechanical skills. We have therefore
condensed the descriptions of each operation
by omitting detailed instructions regarding, for
example, how to loosen or tighten the fixing
devices on the machine, etc.
Do not attempt to carry out procedures which
exceed your level of proficiency, or which you
do not have experience with.
If assistance is required, contact an authorised
service centre.
- E - Operator's manual HD 700
nglish