Publicité
FRONT BRAKE PAD INSPECTION AND REPLACEMENT
3. Replace:
Brake pad
Brake pad replacement steps:
Remove the brake caliper support bolt 1.
Turn the brake caliper 2 counterclock-
wise a.
Replace the brake pads 3.
Connect the transparent hose 4 to the
bleed screw 5 and place the suitable con-
tainer under its end.
Loosen the bleed screw and push the
brake caliper piston in.
CAUTION:
Do not reuse the drained brake fluid.
Tighten the bleed screw.
Bleed screw:
6 Nm (0.6 m • kg, 4.3 ft • lb)
Install the brake caliper 6 and brake cali-
per support bolt 7.
NOTE:
Apply the lithium soap base grease on the
caliper support bolt.
Brake caliper support bolt:
22 Nm (2.2 m • kg, 16 ft • lb)
4. Inspect:
Brake fluid level
Refer
to
INSPECTION" section in the CHAP-
TER 3.
5. Check:
Brake lever operation
A softy or spongy feeling → Bleed
brake system.
Refer
to
BLEEDING" section.
3 - 18
INSP
ADJ
"BRAKE
FLUID
LEVEL
"BRAKE
SYSTEM
AIR
Publicité
