Bronpi LONDRES Instructions D'installation, D'utilisation Et D'entretien page 42

D2.35
In order to facilitate the cleaning and/or replacement of the glass, the option
of lifting the door is ruled out; the door must be opened in a folding manner
(from right to left). In this case, the safety handle should be closed to prevent
accidental lifting of the door this point is very important, because if we do not
perform the blockage and knock down the door, we can seriously damage the
supports. Proceed to the opening of the door using the handle that you will find in
the accessory box.
To do this, first of all, remove the trims that are on each side of the inside face
of the frame (see drawing D2.36), raise the door to access the trims with more
comfort, you must pull up to save the hook with which they are fastened. (see
drawing D2.37)
D2.37
After cleaning and/or replacing the glass, you must close the door again and
proceed in reverse:
- Push the door towards the front to close it. When the right part of the door is
close to the closing, we will raise it slightly so that the anchors enter the hole more
smoothly. Once you have entered the holes (see drawing D2.38), push the door
hard against the front to make sure it has completely closed.
- Close the door hook.
- Proceed to open the safety handle, for the use of the lifting door.
- Raise the door and place the frame trims.
IMPORTANT: The cleaning of the glass must be carried out with the device cold. Special care should be taken when
opening the door to ensure that the door handle is closed and that there is no accidental lifting of the door that could
cause the glass to break.
D2.38
2.3.6 RIOJA AND COLISEO MODELS
PLACING / REPLACING THE STANDARD FRAME
The Rioja and Coliseo models incorporate a standard three-sided frame. Optionally you can purchase the lower profile of the frame to convert
it into 4 sides. Its installation is quite simple (see drawing D2.39):
1. In order to place the lower profile, it is not necessary to remove the standard frame.
2. On each side of the insert, you will find 2 holes.
3. You must place the lower profile on the holes and screw the supplied screws.
4. The profile must be perfectly adjusted either frontally or laterally to the standard frame.
2.3.7 CAIRO SERIES
PLACEMENT OF INTERIOR PARTS OF THE COMBUSTION CHAMBER
Optionally, on the Cairo-90 or Cairo-110 models, the interior of the combustion chamber can be made of vermiculite or ceramic. Therefore,
together with your appliance you will receive a box with all the parts of the interior of the combustion chamber of the chosen material. Before
switching on the appliance, you must correctly place all the parts:
- First of all, you must place the side parts (see drawing D2.40). Obviously in the Cairo-E models, you will only have one side part.
- Subsequently place the rear parts (see drawing D2.41), in this case the Cairo-D models lack rear parts.
- With the placement of the deflector, all the interior parts will be correctly placed, preventing their movement.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
When lowering the door to close it, we can observe that just before reaching the final closing position, the
door will move towards the front so that the combustion chamber is sealed. Then, you should lower a few
millimeters more, sliding against the front until it hits the lower stops. (see drawing D2.35)
CLEANING AND/OR REPLACEMENT OF THE GLASS IN MODEL
PARIS 90V-G
41
D2.36
D2.39
INSERTS