Bronpi LONDRES Instructions D'installation, D'utilisation Et D'entretien page 39

2.3.3 MODEL EVEREST VISIÓN
This model include on the top an oven with an hermetic oven chamber. The base of the oven is made of ceramic material (it absorbs heat and
irradiates it). Heating is produced when the smoke passes through the sides and the upper part of the oven. On the roof of the oven there is
one pipe that connects the cooking chamber with the smoke outlet in order to remove the gas generated in the oven.
The oven has the following components:
- Bimetallic thermometer It is disassembled and it place is the glass of the oven.. To install it, it is necessary to introduce the
thermometer through the hole of the door and, then, put the rubber and the nut on the backside (see drawing D2.23).
WARNING!! The thermometer shows the cooking temperature of the oven, it never shows the combustion chamber
temperature.
The maximum cooking temperature for the oven is 200-230ºC. If the thermometer shows that the oven reaches a higher
temperature, this means that the equipment has been overloaded and this will invalidate the warranty.
- Tray. It is made of stainless steel. The tray must not come into contact with food. In order to avoid the damage of the tray, it is
recommended to extract it outside the oven when it is not being used.
- Roasting grille If you prefer, instead of the tray you can use a roasting grille of 38x47cm. In order to avoid the damage of the tray, it is
recommended to extract it outside the oven when it is not being used.
- Ceramic pieces They are placed on the base of the oven. Their purpose is to absorb heat and irradiate it.
The inside of the oven of this model is composed for 4 pieces (2 guides, ceiling and rear) made in stainless steel removable to extract them
and make easier the cleaning.
To remove the pieces we will follow the next steps (see drawing D2.24).
1. Remove the ceiling, slipping it out.
2. Remove the laterals guides hanging in 4 supports. To remove it you have to raise the guide and then pull it off.
3. Remove the rear hanging in two supports.
D2.25
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
2.3.4 ALL THE MODELS FLORIDA SERIES AND MOD. MERIDA
The standard frame included with the inserts is removable to make easier the installation and the repair /
replacement of the electrical components (fan, thermostat, etc.).
To remove the standard frame it is necessary unscrew the 4 screws located on the upper and lower edge (2
on each edge) (see drawing D2.25).
WARNING!! To be able to repair / replace the electrical components of the insert it is
essential to have a easy way to uninstall the frame.
2.3.5 ALL MODELS PARIS SERIES
BLADE AIR REGULATION
If you want to channel air to other rooms, use a hammer to release the 2 hot air outlets at the top of the insert
(see diagram D2.26). Otherwise, with the two upper outlets closed, the air will come out through the front
of the appliance, for this you must have the adjustment blade open at the front of the insert. (see drawing
D2.26) In the Paris 90V-G model, air can only exit through the channeling exits (not through the front), so this
model does not have such a regulation blade.
38
D2.23
D2.24
INSERTS