Bronpi LONDRES Instructions D'installation, D'utilisation Et D'entretien page 32

Smoke outlet collar
In the Coliseo, Rioja and Cairo-70 models, the installer must
set the smoke outlet collar. This allows the installer to get an
easier installation, specially when the appliance is going to be
inserted in a preexisting fireplace whose height is similar to the
height of the appliance (see drawing D2.14).
In order to install it, it is necessary to access from the inside of
the combustion chamber and proceed as follows:
1. Remove the baffle plate.
2. It is recommended to place ceramic glue (not supplied)
on the smoke outlet collar itself, to ensure its tightness
with the appliance.
3. Screw the ring to the ceiling of the insert itself with the three screws supplied.
4. Do not forget to install the baffle plate again before using the insert.
Baffle plate
The baffle plate is a fundamental part for the proper operation of the insert. It must be placed in the right position and the insert must not
be used without the baffle plate. This would invalidate the warranty.
WARNING!
The lack of the baffle plate causes an excessive draught. This causes a fast combustion, excessive wood consumption and
the overheating of the equipment.
Due to safety reasons during the transport, in some models, the baffle plate is not assembled. You will find it inside the combustion chamber.
The correct position should be the following one (see drawing D2.15).
For Cairo series models, refer to section 2.3.7 of this manual for proper deflector placement.
Some models such as Londres and Londres-T have in addition a double baffle-plate which the same function (see drawing D2.16).
Barbecue grill
The barbecue grill is an accessory that incorporates the models of the series Paris. It is
adjustable in two heights depending on the slot of the lateral guide used. To prevent its
deterioration, it is advisable to remove it when not in use (see drawing D2.17).
Forced ventilation
D2.18
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
1
D2.16
Some inserts are provided with axial fans of 160 m
adequate to improve the heat distribution by the ventilation of the
room or the room beside.
However, the model Londres-T include a tangential turbine of 680 m
optionally have the tangential turbine of 680 m
The Cairo models of double door (Cairo-D) have optionally the possibility of incorporating two turbines of 400
m /h each one of them. The Cairo-70 model incorporates a 225 m3/h blower as standard.
3
The models of the Paris series incorporate as standard a tangential turbine can be of 225, 290 or 335 m
according to the measurement of the model.
The operation of the Londres-T model turbine is explained in section 2.1. While the operation of the Cairo series
turbine is explained in section 2.2.
2
/h each one,
3
/h, while the Cairo and Cairo-E models can
3
/h.
3
31
D2.14
D2.15
D2.17
/ h,
3
INSERTS