Bronpi LONDRES Instructions D'installation, D'utilisation Et D'entretien page 38

Electrical connection
Disconnect from power before any electrical handling.
First of all, we will connect the temperature sensor which is provided with the switchboard to the insert according the attached drawing.
Connect the fan with the switchboard and later connect the switchboard and the electrical network (see electrical scheme).
Probe placement
Heat exchanger (only model Londres-V)
The heat exchanger that cross the hood of the insert must not be blocked, it is necessary
to leave the holes open in order to achieve a better ventilation of the insert, increasing its
performance. (see drawing D2.20).
Replacement of the electrical components (only models Londres-T and Londres-T Visión)
It is compulsory to leave an access in the central low part of the masonry or facing to
D2.21
the repair / replacement of the turbine in case of breakdown. This register may be a
grille with minimal measures 400x200mm (wide x high).
Placement of optional frames
The standard frame included with models Londres, Londres-V, Londres-T and
Londres-T Visión are removable. To place an optional frame (M-8, M-9, etc.) it is
necessary to remove the standard frame and then replace the optional one with the
same grills. To remove the standard frame it is necessary unscrew the 4 screws of the
frame (2 in each side). Then, place and screw again the new frame (see drawing D2.21).
2.3.2 MODEL EVEREST
Some models include on the top an oven with an hermetic oven chamber. The base of the oven is made of refractory brick (it absorbs heat and irradiates
it). Heating is produced when the smoke passes through the sides and the upper part of the oven. On the roof of the oven there is one pipe that connects
the cooking chamber with the smoke outlet in order to remove the gas generated in the oven.
The oven has the following components:
- Thermometer It is disassembled and you can find it in the baking
tray. It shows the cooking temperature of the oven. To install it, it is
necessary to introduce the sheath through the hole of the door and,
then, put the nut (see drawing D2.22).
WARNING!! The thermometer shows the cooking temperature
of the oven, it never shows the combustion chamber
temperature.
The maximum cooking temperature for the oven is 200-230ºC.
If the thermometer shows that the oven reaches a higher temperature, this
means that the equipment has been overloaded and this will invalidate the
warranty.
- Tray. It can be adjustable in two different levels according to the slot that we use. The tray must not come into contact with food. In
order to avoid the damage of the tray, it is recommended to extract it outside the oven when it is not being used.
- Refractory bricks. They are placed on the base of the oven. Their purpose is to absorb heat and irradiate it.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
WARNING!! If the insert is installed and covered and you want to buy another new one optional frame it
is important to advice of this to your distributor when you are going to ask for it.
Switchboard wiring diagram
37
N F
D2.20
D2.22
INSERTS