Bronpi LONDRES Instructions D'installation, D'utilisation Et D'entretien page 40

TURBINE REPLACEMENT
In case of replacement of one of the electrical components, in the models of the series Paris
frontal, and models with lifting door (Paris 90V-G), the operation of substitution can be made
without uninstalling the insert because they are placed under the base. It is possible to access the
components through the combustion chamber by following the next steps. (see drawing D2.27)
1. Remove the vermiculite baffle plate.
2. Remove the cast-iron back and side plates.
3. Remove the cast iron grate.
4. Remove the screws from the fan bracket, lift it from the left side and remove it. Be careful
with the cables of the installation.
In the case of the corner and three-sided inserts of the Paris and
Versailles series, the steps would be as follows (see drawing
D2.28):
1. Remove the vermiculite side plates by pulling upwards
from the front.
2. Remove the baffle plate.
3. Remove the cast iron grate pulling it out from the sides.
4. Remove rear cast iron plates.
5. Remove the screws from the fan bracket, lift from the
left side and remove it. Be careful with the cables of the
installation.
PLACING / REPLACING THE STANDARD FRAME
All inserts in this series incorporate a standard frame. The standard frame is detachable for an easy installation.
To uninstall the standard frame, proceed as follows:
Front models (see drawing D2.29):
1. Remove the door, opening it and pulling it upwards.
2. Unscrew the frame screws, as indicated in the drawing.
3. Remove the frame and install the insert, fix it and reassemble the frame and the door.
Corner and three-sided models (see drawing D2.30):
1. Remove the rear screws from both the top and bottom frames and pull them out.
2. Remove the screws from the vertical frames and remove frames.
3. Install the insert, fix it and reassemble the frames.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS 39
D2.26
D2.27
D2.28
D2.29
INSERTS