Bronpi LONDRES Instructions D'installation, D'utilisation Et D'entretien page 41

OUTDOOR AIR INTAKE
In the models of the Paris series, it is possible to choose that the entrance of primary air comes from a contiguous place or even from outside
of the house.
In the case of providing air from outside or from a contiguous place, you must purchase the optional kit (KIT-AIR2) for external air intake
(airtight). Simply connect the KIT with a 100 mm diameter pipe to the chosen place. Keep in mind that a too long pipe or with too many
deviations (elbows), far from benefiting the intake of air, causes a great loss of load and, therefore, can cause combustion problems.
Do not forget that this external air intake is independent and different from the input needed for the ventilation unit (turbine), so the decoration
or masonry made to the insert, must have a sufficient air circulation for the flow of the turbine (see drawing D2.31).
The procedure for placing the optional external air intake kit is as follows:
- Position the kit below the plane of fire. You must center the kit and position it on the front (inner face) as indicated in the image.
- With the supplied self-drilling screws, connect the kit to the base of the appliance.
- Connect the air intake to the exterior or selected environment through a 100 mm diameter pipe.
-
D2.32
forget to use the supplied glove or the "cold hands" accessory provided in the accessory box
to manipulate the door opening when the appliance is hot and there is a risk of burns.
Also, at the top of the door is a safety system that must remain open to allow the door to be
raised and lowered.
ATTENTION!!!! The appliance will be received with the system closed to prevent the door from
being lifted during transport. Don't forget to open the handle so that you can lift the door.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
DOOR CLOSURE ADJUSTMENT
It is advisable to check the effective state of the door seals because if they are not perfectly intact
(i.e. they no longer fit with the front and/or door), they do not ensure the correct functioning of the
insert! You can control the adjustment of the door according to the progressive wear of the seals
through the screws found on the front; by tightening and loosening these screws will get the correct
adjustment of the door. (See drawing D2.32)
OPERATION: FUEL RECHARGEING ON PARIS
90V-G MODEL
In the Paris 90V-G model, the door can be raised,
thanks to a system of counterweights and pulleys,
the door can be easily opened. Two handles are
integrated in the door to facilitate its lifting. Do not
For refuelling, the use of the lifting door is
recommended to facilitate operation.
NOTE: It is MANDATORY to disconnect the operation of the turbine (position 0) when the lift door of
the insert is opened, since depending on the smoke installation it is possible that small turbulences
are created in the combustion chamber, causing the exit of smoke and/or ashes to the room where
D2.34
the device is installed.
40
D2.30
D2.31
D2.33
INSERTS