Transmission Oil - Malaguti centro 125 ie Manuel D'entretien Et D'utilisation

5.3

TRANSMISSION OIL

1
Checking level/topping up
1) Place the vehicle on a level surface on its centre
2
stand.
2) Unscrew the oil filling screw (A-Fig.24)
3) If necessary, top up with the recommended type of
3
oil (Q8 CLASS 10W40) until it overflows.
4) Refit and tighten the oil filling screw.
4
Renew after the first 1,000 km (624 mi) and every 12,000
km (7,440 mi)
5 1) Place the vehicle on a level surface on its centre
stand.
2) Put a container under the crankcase.
6
3) Loosen the drainage (B-Fig.24) and filling (A-Fig.24)
screws.
4) Clean the drainage screw, refit and tighten in
place.
5) Fill crankcase with the recommended type of oil
(Q8 CLASS 10W40) until it overflows (150cc).
6) Refit and tighten the oil filling screw.
ENG Perform this operation with the engine off and
cold.
Prevent
transmission crankcase during checks or oil
changes. Prevent oil dripping on tires or wheels.
28
All manuals and user guides at all-guides.com
foreign matters from
Regularly check for oil leakages near drain cap
at the rear wheel. If you notice any leaks, contact
an Authorised MALAGUTI Service Centre.
Hand waste oil over to an authorised waste
diposal centre, in accordance to laws in force.
getting into
B
A
Fig.24