Digital Clock - Malaguti centro 125 ie Manuel D'entretien Et D'utilisation

3.11.1 ELECTRICAL FAULT / SERVICE WARNING LIGHT

When the key is turned to position
the engine, the orange light
2
light ) come on for a few seconds to test operation.
In normal conditions, after the test cycle, the light goes
3 off. If the light remains on (steadily lit and/or flashing),
either of the following situations may be present:
• Electrical Fault (alternate short and long flashes):
4
this means that the vehicle's electrical equipment is
not in working order. Have your vehicle checked as
soon as possible by an Authorised MALAGUTI Service
5
Centre.
• SERVICE (15 short flashes): this means that scheduled
maintenance must be performed (see Maintenance
6
Table in chap.5.2). Contact an Authorised MALAGUTI
Service Centre.
In both cases, as well as during scheduled
maintenance work, the Authorised MALAGUTI
Service Centre will reset the SERVICE signal after
performing the necessary work.
SERVICE signal frequency, which is indicated by
ENG
the light, may not correspond to the indications
provided in the Maintenance Table. Frequency of
scheduled maintenance, in fact, depends on how
and where the vehicle is used, etc. In these cases,
contact an Authorised MALAGUTI Service Centre.
6
All manuals and user guides at all-guides.com

3.11.2 DIGITAL CLOCK

, without starting
To select clock functions, proceed as follows:
• reading date and month
(along with the red
• reading seconds
To set the time or date, use the two buttons of the dial,
starting from time display mode.
• setting month
• setting date
• setting time
• setting minutes
Press the bottom button again to return to time display
mode. If you have changed your settings, save them by
pressing the top button.
press top button once (time will appear automatically
after a few seconds).
press top button twice; to resume the initial
configuration, press the button again.
press the bottom button twice and select the correct
number with the top button.
press the bottom button 3 times and select the
correct number with the top button.
press the bottom button 4 times and select the
correct number with the top button.
press the bottom button 5 times and select the
correct number with the top button.