Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Topping up
Before topping up, check the oil level and in no case
allow the level to rise above the MAX notch.
2
Never allow the level to rise above the MAX
mark! Excessive internal pressure can impair
performance and cause malfunctioning or
3
damage to the engine.
Waste oil is toxic for the environment, therefore
4
we suggest you contact an Authorised MALAGUTI
Service Centre for disposal according to the rules
in force.
5
Change engine oil and clean the filtering net
after the first 1000 km (624 mi)
6
and every 4000 km (2496 mi)
) Warm the engine up for a few minutes.
2) Stop the engine. Put an oil container under the
engine and remove the dipstick (A‑Fig.26).
ENG
F
Fig.26
30
All manuals and user guides at all-guides.com
A
1
S
3
3) Remove drainage cap (S‑Fig.26) and let oil flow
out.
4) Remove filter cap (F‑Fig.26).
5) Clean the oil filtering net (1‑Fig.27) with solvent.
6) Check
the
damaged.
7) Refit O-ring, compression spring (2‑Fig.27), oil filtering
net and tighten filter cap.
Make sure the O‑ring is correctly seated.
8) Refit drainage cap and wrench.
9) Fill the engine with 800cc. of Q8 CLASS 10W40 oil and
refit the dipstick.
0)Run the engine and let it warm up; check for any
leaks. If leaks are noted, stop the engine and locate
their cause.
) Repeat engine oil level check (see "Checking the oil
level" chap.5.4).
Letting the engine run with an insufficient amount
of lubricant or with the wrong types of lubricant
causes wear to moving parts and can in the long
run cause serious damage.
Waste oil contains polluting substances. Have oil
2
replaced by an Authorised MALAGUTI Service
Centre that will also dispose of waste oil in
accordance to the law.
Fig.27
O-ring
(3‑Fig.27)
and
replace
if
Publicité
Table des Matières
