Stryker S3 MedSurg Bed with StayPut Frame Mode D'emploi page 42

A confirmation notification indicates that weighing the patient was successful (Figure 30).
N N o o t t e e - - To clear the patient weight from the display, press the S S c c a a l l e e button again. The patient weight is still recorded in the
weight log.
N N o o t t e e
• Always calibrate the bed after adding a support surface or mattress to the bed frame.
• Always set the scale to zero before putting a patient on the product.
S S e e t t t t i i n n g g t t h h e e s s c c a a l l e e t t o o z z e e r r o o
The zero function clears all of the stored values from the weight log, change patient weight, and gain or loss.
N N o o t t e e - - Always set the scale to zero before putting a patient on the product.
To set the scale to zero:
1. Press and hold the Z Z e e r r o o button (B) (see Footboard control panel - Scale (page 37)) (Figure 31) until the R R e e l l e e a a s s e e
B B u u t t t t o o n n appears (Figure 32).
F F i i g g u u r r e e 3 3 1 1 – – H H o o l l d d t t o o z z e e r r o o
2. Release the Z Z e e r r o o button.
N N o o t t e e - - Do not touch the product when you set the scale to zero (Figure 33).
EN 38
F F i i g g u u r r e e 2 2 9 9 – – D D o o n n o o t t t t o o u u c c h h b b e e d d
F F i i g g u u r r e e 3 3 0 0 – – P P a a t t i i e e n n t t w w e e i i g g h h t t
F F i i g g u u r r e e 3 3 2 2 – – R R e e l l e e a a s s e e B B u u t t t t o o n n
3006-209-005 Rev AA.2