Stryker S3 MedSurg Bed with StayPut Frame Mode D'emploi page 19

T T r r a a n n s s p p o o r r t t i i n n g g t t h h e e p p r r o o d d u u c c t t w w i i t t h h t t h h e e Z Z o o o o m m m m o o t t o o r r i i z z e e d d d d r r i i v v e e ( ( o o p p t t i i o o n n ) )
W W A A R R N N I I N N G G
• Always use caution when transporting the product with the motorized drive wheel. Injury to the patient, operator, or
others, or damage to the product or equipment could occur if the product collides with an obstacle.
• Always use caution when transporting the product through halls, doors, and elevators. Damage to the siderails or other
parts of the product could occur if the product collides with walls or door frames.
• Always put the motorized drive wheel in the neutral position and release the brakes before transporting the product
manually. Do not transport the product manually with the motorized drive wheel in drive as the product will be difficult to
transport and could injure the operator.
C C A A U U T T I I O O N N - - Always make sure that product operation is not affected when you attach equipment to the product.
To transport with the Z Z o o o o m m motorized drive:
1. Unplug the power cord from the wall outlet and secure the cord.
N N o o t t e e - - The motorized drive wheel will not operate if the power cord is plugged into the wall outlet.
2. Turn the battery power switch to on (Figure 6). You can find the battery power switch located at the head end of the
frame on the patient left side.
3. To place the motorized drive wheel in the drive position, push the drive wheel pedal to drive (Figure 7). To place the
motorized drive wheel in the neutral position, push the drive wheel pedal to neutral (Figure 7).
3006-209-005 Rev AA.2
F F i i g g u u r r e e 5 5 – – A A p p p p l l y y i i n n g g o o r r r r e e l l e e a a s s i i n n g g s s t t e e e e r r l l o o c c k k
F F i i g g u u r r e e 6 6 – – B B a a t t t t e e r r y y p p o o w w e e r r s s w w i i t t c c h h
15 EN