Stryker S3 MedSurg Bed with StayPut Frame Mode D'emploi page 37

Masquer les pouces Voir aussi pour S3 MedSurg Bed with StayPut Frame:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

A
Zone
B
Arm/Disarm
N N o o t t e e - - The B B e e d d E E x x i i t t footboard LED indicator illuminates when you arm C C h h a a p p e e r r o o n n e e bed exit (Figure 27).
A A r r m m i i n n g g o o r r d d i i s s a a r r m m i i n n g g C C h h a a p p e e r r o o n n e e b b e e d d e e x x i i t t ( ( o o p p t t i i o o n n ) )
When armed, C C h h a a p p e e r r o o n n e e bed exit monitors the patient's position on the product.
N N o o t t e e - - A notification appears if there is not enough weight on the product to arm bed exit.
To arm bed exit:
1. Set the scale to zero. See Setting the scale to zero (page 38).
N N o o t t e e - - If you do not set the scale to zero before placing a patient on the product, bed exit may not operate as intended.
2. Position the patient on the product.
3. Press and hold the A A r r m m / / D D i i s s a a r r m m button (A). See Footboard control panel - C C h h a a p p e e r r o o n n e e bed exit (option) (page 32).
After arming C C h h a a p p e e r r o o n n e e bed exit, the LED light bars on the footboard illuminate green, the B B e e d d E E x x i i t t footboard LED
indicator illuminates, and the selected zone on the footboard control panel illuminates.
If the patient moves from the armed zone the following will occur:
LED light bars on the footboard flash amber
bed exit indicator LED on the footboard LED indicator flashes
sound alarm is triggered
bed exit status alert is displayed on the display screen
To disarm bed exit, press and hold the A A r r m m / / D D i i s s a a r r m m button again (A). See Footboard control panel - C C h h a a p p e e r r o o n n e e bed exit
(option) (page 32).
F F o o o o t t b b o o a a r r d d c c o o n n t t r r o o l l p p a a n n e e l l - - C C h h a a p p e e r r o o n n e e b b e e d d e e x x i i t t w w i i t t h h z z o o n n e e c c o o n n t t r r o o l l ( ( o o p p t t i i o o n n ) )
W W A A R R N N I I N N G G
• Do not use bed exit to replace patient monitoring protocol. Bed exit is intended only to aid in the detection of a patient
exiting the product.
• Do not use bed exit with patients who weigh less than 50 lb (23 kg).
3006-209-005 Rev AA.2
A
B
The patient can move freely, but the alarm sounds when the patient
attempts to leave the product
Arms or disarms bed exit
33
EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

3002

Table des Matières