Stryker S3 MedSurg Bed with StayPut Frame Mode D'emploi page 17

S S e e t t t t i i n n g g u u p p i i B B e e d d W W i i r r e e l l e e s s s s ( ( o o p p t t i i o o n n ) )
W W A A R R N N I I N N G G - - Always associate or map the i i B B e e d d L L o o c c a a t t o o r r to the room or location to provide accurate location information. If
you move an i i B B e e d d L L o o c c a a t t o o r r after it has been installed and mapped, you must remap to the new room or location.
To setup i i B B e e d d W W i i r r e e l l e e s s s s :
Install the 5212 i i B B e e d d L L o o c c a a t t o o r r ™ on the wall at the head end of the product. The i i B B e e d d L L o o c c a a t t o o r r communicates with the IR
module that is installed in your product. For detailed instructions about how to mount the i i B B e e d d L L o o c c a a t t o o r r , see the instructions
for use that was included with your i i B B e e d d L L o o c c a a t t o o r r installation kit.
Contact Stryker Technical Support with any installation questions ( Contact information (page 10)).
N N o o t t e e - - You must load the wireless connection settings before the device will communicate with the i i B B e e d d Server application.
See the i i B B e e d d Server Installation and Configuration manual.
3006-209-005 Rev AA.2 13 EN