Stryker S3 MedSurg Bed with StayPut Frame Mode D'emploi page 36

A Bed motion lock
B Fowler 30°+
C Patient control Fowler lock
D Patient control Gatch lock
Bed height lock
E
N N o o t t e e
• The C C P P R R button overrides all lockouts.
• The corresponding lock LED illuminates when you lock a motion control.
• The B B e e d d M M o o t t i i o o n n L L o o c c k k footboard LED indicator illuminates when you lock bed motion.
• The F F o o w w l l e e r r 3 3 0 0 ° ° + + footboard LED indicator illuminates when you lock the Fowler.
• If the product is in a specific position when a lock is enabled, the product will be locked in that position.
• Lock parameters are saved when the product is unplugged or during a power failure.
• Do not lock the control panel functions from the footboard if you must access the control panel when you remove the
footboard.
F F o o o o t t b b o o a a r r d d c c o o n n t t r r o o l l p p a a n n e e l l - - C C h h a a p p e e r r o o n n e e b b e e d d e e x x i i t t ( ( o o p p t t i i o o n n ) )
W W A A R R N N I I N N G G
• Do not use bed exit to replace patient monitoring protocol. Bed exit is intended only to aid in the detection of a patient
exiting the product.
• Do not use bed exit with patients who weigh less than 50 lb (23 kg).
• Always follow patient monitoring protocol to avoid patient injury. Power save mode is active after one hour on battery
power and no motion release switch activation. Bed exit, scale, and motion functions will not operate while the product is
in power save mode.
EN 32
A
B
D
C
Locks all motion controls from the operator control panel and patient
control panel
Press and hold to raise and lock the Fowler at 30°.
You can raise the Fowler between 30° and 60° after you lock the Fowler
at 30°+.
Locks or unlocks the Fowler
Locks or unlocks the Gatch
Locks or unlocks the litter
E
3006-209-005 Rev AA.2