Stryker S3 MedSurg Bed with StayPut Frame Mode D'emploi page 21

The P P l l u u g g b b e e d d i i n n t t o o c c h h a a r r g g e e LED illuminates while the battery power switch is on and the battery level is low ( Battery backup
panel (option) (page 50)).
To charge the battery:
1. Plug the power cord into a wall outlet.
N N o o t t e e
• The batteries will have a full charge within approximately 10 hours.
• Three LEDs on the head end control panel may illuminate with products that have the Z Z o o o o m m option ( Z Z o o o o m m motorized
drive panel (option) (page 51)), even in power save mode. The battery power switch LED on the lower left corner of the
head end will illuminate when the unit is in power save mode.
A A c c t t i i v v a a t t i i n n g g t t h h e e C C P P R R r r e e l l e e a a s s e e
C C A A U U T T I I O O N N - - Always make sure that all persons and equipment are away from the area below and around the Fowler before
you activate the CPR release. The CPR release is for emergency use only.
When you raise the Fowler and need quick access to the patient, you can position the product to 0° by activating the CPR
release.
You can find the two CPR release levers at the head end section on both the left and right sides of the Fowler (A) (Figure 9).
To activate the CPR release:
1. Grasp and squeeze the lever on either side of the Fowler.
2. Guide the Fowler to the flat position.
R R a a i i s s i i n n g g t t h h e e l l o o w w e e r r l l e e g g s s e e c c t t i i o o n n
Prop the footrest to raise the lower leg section manually.
To raise the lower leg section:
1. Grasp the lower leg section with both hands (A) (Figure 10).
3006-209-005 Rev AA.2
A
F F i i g g u u r r e e 9 9 – – A A c c t t i i v v a a t t i i n n g g t t h h e e C C P P R R r r e e l l e e a a s s e e
17 EN