Laser Safety - Evolution EVOSAW 230 Instructions D'origine

www.evolutionpowertools.com
Laser Guide System
This machine is fitted with a laser guide system, which is intended as
a guide only and should not be relied upon for the accuracy of a cut.
Remove the battery compartment (Fig.11) cover and fit the
supplied batteries, taking care to observe the correct polarity,
and then replace the cover.
Press the switch to the on position to activate the laser.
(Fig. 12) Align the laser with a line of cut guide slot, if
necessary, by means of the adjustment screw on the LH side of
the laser module housing. (Fig.13)

LASER SAFETY

The laser guide line used in this product uses a class 2 laser
with a maximum power output of 1.5mW at a wavelength of
between 635 and 670nm. These lasers do not normally present
an optical hazard, although staring at the beam may cause
temporary flash blindness.
WARNING: Do not stare directly at the laser beam.
The laser must be used and maintained as detailed in this manual.
Never intentionally aim the laser beam at any person and prevent
it from being directed towards the eye, or an object other than the
workpiece. Always ensure that the laser beam is directed at the
workpiece only and never at another person or animal.
Never direct the laser beam onto any bright, shiny, reflective
surface, as the laser beam could be reflected back towards the
operator. Do not change the laser unit for any other type.
Do not tamper with the laser unit. Only touch the unit when
making adjustments. Repairs to the laser shall only be carried
out by an authorised service centre.
Note: The following WARNING labels may be found on this machine:
LASER RADIATION
DO NOT STARE INTO THE BEAM
CLASS 2 LASER PRODUCT
Fig. 11
Fig. 12
Fig. 13
19
EN
ES
FR