Rotating The Pump Reservoir - MINN KOTA RAPTOR Mode D'emploi

ROTATING THE PUMP RESERvOIR

Rotating the Pump Reservoir
After reviewing the mounting considerations for your installation, you may have identified that the reservoir on your Pump Assembly needs to be
rotated. If your installation requires rotating the Pump Reservoir, please follow the instructions below. If your installation does not require the
Pump Reservoir to be rotated, please see "Installing the Hydraulic Pump " section of these instructions.
1
ITEM(S) NEEDED
a. Take the Pump Assembly (Assembly D, E, or F) and
identify the four Flanged Bolts that hold the Pump
Reservoir in place on the Pump Assembly.
b. Using a 5/16" Deep Well Socket or 5/16" Ratchet
Style Wrench, remove all four Flanged Bolts and set
them aside.
NOTICE:
Do not pull the Pump Reservoir off of
the Pump Assembly. It is recommended to rotate
the Pump Reservoir in place to maintain a proper
seal between pump components.
2
c. Determine which direction the Pump Reservoir will
be rotated. While firmly holding the top of the Pump
Assembly, rotate the Pump Reservoir to its new
position. Complete the rotation be making sure that
the holes in the Pump Reservoir are aligned with the
holes for the Flanged Bolt.
NOTICE:
If the Pump Reservoir becomes
detached from the Pump Assembly, make sure
that the O-ring that sits on the bottom of the Pump
Manifold is fully seated in the groove along the
assembly. In the event that the reservoir needs to
be pushed back in place on the Pump Assembly,
make sure that the O-ring does not get pinched
between the pieces. An improperly seated seal
between components will affect pump operation.
14 | minnkotamotors.com
#D, E, or F x 1
1a
Pump Assembly Pump Assembly
Pump Pump
Reservoir Reservoir
Flanged Bolts Flanged Bolts
2c
Align Holes Align Holes
Reservoir Reservoir
Rotation Rotation
2c
Manifold Manifold
Pump Pump
Reservoir Reservoir
1b
Flanged Flanged
Bolts Bolts
2c
Align Align
Reservoir Reservoir
Holes Holes
Rotation Rotation
Properly Properly
Seated Seated
O-ring O-ring
©2020 Johnson Outdoors Marine Electronics, Inc.