MINN KOTA RAPTOR Mode D'emploi page 25

Installing the Remote Bracket
The Raptor comes with two remotes. Mounting the Remote Bracket to your boat is an option installation. The Remote Bracket is only intended
to hold one remote. Mounting the Remote Bracket in the boat is based on personal preference. It is recommended to mount the Remote
Bracket to a flat surface where the remote can be easily accessed for anchor control. Avoid a space where the buttons on the remote may be
accidentally actuated. To mount the bracket, follow the steps below:
1
ITEM(S) NEEDED
a. Select a flat mounting location for the Remote
Bracket. Check the location for fit and function of
the Bracket Holder. Clean and thoroughly dry the
mounting surface. Once satisfied with the location,
take the Foam Tape (Item #32) and pull the
backing off of one side of it. Install the Foam Tape
with the exposed adhesive facing toward bracket,
approximately centered on the back of the Remote
Bracket (Item #30). Press and hold in place for
30 seconds.
b. Remove the backing on the outside of the Foam Tape
to expose the adhesive. Place the Bracket Holder to
the mounting location. Firmly press and hold for
30 seconds.
2
ITEM(S) NEEDED
c. Take one of the Raptor remotes (Assembly G) and
place it in the Bracket Holder.
d. It is also optional to place the Lanyard (Item #28 X 1)
on either of the Raptor remotes.
NOTICE:
The two Raptor remotes that come
with the Raptor from the factory are pre-paired. If
the network connection between the remotes and
the anchor is interrupted, please see "Pairing the
Raptor" section of these instructions.
©2020 Johnson Outdoors Marine Electronics, Inc.
#32 X 1 #30 X 1
INSTALLING THE REMOTE BRACKET
1a
Remote Bracket
(back)
Foam
Tape
#28 X 1
2c
1b
Remote Bracket
(front)
#G X 1
2d
minnkotamotors.com | 25
Mounting
Surface