MINN KOTA MKA-55 Mode D'emploi

Compatible with most Minn Kota ® Electric-Steer, Bow-Mount Trolling Motor models, including the Ulterra™, Terrova ® , PowerDrive™,
PowerDrive V2, and PowerDrive Pontoon.
Item /
Part # Description
Assembly
A
2992370 STABILIZER, BOW MOUNT E.STEER ASM
Items 2-22
2 2372675 PIN, BOW MOUNT STABILIZER
4 2373720 PLUNGER, BOW MOUNT STABILIZER
6 2370111 KNOB, BOW MOUNT STABILIZER, TRI-LOBE
8 2371680 BASE, REMOVABLE, BOW MOUNT STABILIZER
10 2373300 SWIVEL BASE, BOW MOUNT STABILIZER
12 2373825 STRAP, BOW MOUNT STABILIZER
14 2373142 NUT-HEX, M6, BOW MOUNT STABILIZER
16 2373640 ROD, BOW MOUNT STABILIZER
18 2371991 BASE, BOW MOUNT STABILIZER
20 2372370 BODY, BOW MOUNT STABILIZER
22 2263107 NUT-HEX 3/4-10 UNC NYLON
B
2994934 BAG ASM, EL.STEER STABILIZER
Item 24
24 2263434 SCREW-#8-18X1" PPH S/S
26 2370870 CLAMP-STRAP, BOW MOUNT STABILIZER
28 2383479 SCREW, #6-19X.500 PRH TYPE A SS
✖ Not shown on Parts Diagram.
▲ This part is included in an assembly and cannot be ordered individually.
NOTICE:
Images are a graphical representation and
may vary from your motor. Save the packaging! A
template for installation is printed on the back of the
card included in the packaging.
TOOLS AND RESOURCES REQUIRED
• Drill
• 9/64" Drill Bit
MOUNTING CONSIDERATIONS
The Bow Mount Stabilizer Kit is used to stabilize the motor Shaft
and Control Head to reduce bouncing when the motor is stowed and
transported. Attention to detail is needed for successful installation.
Before mounting the Bow Mount Stabilizer Kit, give consideration to
the following:
1. Minn Kota recommends mounting the Bow Mount Stabilizer
Bracket along the trolling motor Shaft reasonably close to the
Control Head when the motor is stowed.
2. Boats vary in the construction of the deck and gunwale. Make
sure the area under the mounting location is flat, clear to
drill holes and install screws. It may be necessary to shim or
modify the deck or gunwale under the mounting location to
create a flat area for the base to be mounted.
©2019 Johnson Outdoors Marine Electronics, Inc.
MKA-55 BOW MOUNT STABILIZER KIT
Qty.
1
1
1
1
1
1
1
1
1
1
1
1
1
4
1
1
• #2 Phillips Screw Driver
• Awl, pencil or similar marking tool
A
B
24
• Scissors
• Hack Saw
Inboard View
Complete Typical Installation
Outboard View
Complete Typical Installation
1862051
26
28
20
6
12
16
22
10
2
4
18
minnkotamotors.com | 1
14
8