MINN KOTA RAPTOR Mode D'emploi page 13

4
ITEM(S) NEEDED
#2 x 4
f. Take each of the four 3-1/2" Stainless Steel Hex
Head Cap Screws (Item #6) and place one Flat
Washer (Item #2) on them. Apply anti-seize (Item
#10) to the hardware. Place one screw in each of the
Mounting Holes so that it passes through the Built-
in Mounting Bracket and the drilled holes on the
transom of the boat.
g. Place a Fender Washer (Item #4) on the end of each
Screw on the inside of the Transom and then secure
each with a Flange Nut (Item #8). Apply anti-seize
to the threads before tightening. Tighten the screws
with a 9/16" Box End or Socket Wrench. Do not
over-tighten. Tighten to 20 ft-lbs. Recheck mounting
hardware periodically to make sure it remains tight.
NOTICE:
To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
Applying an anti-seize may help prevent seizing.
NOTICE:
If you are replacing a Talon with the
Raptor, DO NOT REUSE the 5/16" Talon mounting
hardware for mounting purposes.
©2020 Johnson Outdoors Marine Electronics, Inc.
#4 x 4 #6 x 4
INSTALLING THE RAPTOR
#8 x 4
Hydraulic Hydraulic
4f
Hoses Hoses
Transom Transom
Drilled Drilled
Holes Holes
Built-in Built-in
Mounting Mounting
Bracket Bracket
4g
Hydraulic Hoses
Fender
Flange
Washer
Nut
Transom
#10 x 1
Stainless Steel Hex Stainless Steel Hex
Head Cap Screws Head Cap Screws
Flat Washers Flat Washers
Built-in Mounting Bracket Built-in Mounting Bracket
minnkotamotors.com | 13