Completing The Installation - MINN KOTA MKA-32 Guide Rapide

Completing the Installation

1
ITEM(S) NEEDED
a. Slide the Top Plate attached to the motor back onto
the Bottom Plate that was mounted to the Bow
of the boat and secure with the Cam Lever and
Pin. Always check to be sure that the Cam Lever
is latched and the latch is secured with the Pin to
ensure that the Cam Lever remains latched.
b. The Cover (Item #16) is available to use when the
motor is not mounted on the boat. To install the
Cover, place it on top of the Bottom Plate. Press
down on the center of the Cover while latching the
Cam Lever with the Ring Pin. The Cover should fit
snugly to the Bottom Plate.
NOTICE:
Lock your motor to help prevent theft.
For warranty information, please visit
minnkotamotors.com
Part #2377116
#16 x 1
minnkotamotors.com.
Minn Kota Consumer & Technical Service
Johnson Outdoors Marine Electronics, Inc.
PO Box 8129
Mankato, MN 56001
1a
1b
Top Cover Top Cover
Bottom Bottom
Plate Plate
121 Power Drive
Mankato, MN 56001
Phone (800) 227-6433
Fax (800) 527-4464
ECN 40110
1b
©2020 Johnson Outdoors Marine Electronics, Inc.
All rights reserved.
Rev K 09/20