MINN KOTA RAPTOR Mode D'emploi page 10

HYdRAULIC PUMP MOUNTING CONSIdERATIONS
6. Power Source - Make sure that the power cord can reach its
intended power source and will not pose as a tripping hazard. It
is recommended to mount the pump as close to the power source
as possible to create the least obtrusive routing for cables between
the pump and power source.
7. Bypass Access - On the side of the hydraulic pump manifold,
there are two acorn nuts that cover manual Bypass Valves in the
event of the need to Emergency Stow. The installation kit comes
with a Pressure Wrench (Item #2358800). Be sure that the
installation location allows a minimum of 1-1/2 inch clearance
around the "BP" on the pump manifold to access these acorn nuts
and the Bypass Valves below them and enough space to utilize the
Pressure Wrench. Store the pressure wrench in the boat.
8. Reservoir Clearance - When selecting the mounting location,
it may be necessary to rotate the position of the reservoir on the
hydraulic pump to accommodate for tight mounting locations. The
hydraulic pump comes out of the box with the reservoir fill cap
directly below the hydraulic hose fittings on the pump manifold.
The reservoir can be rotated 90 degrees to either the right or the
left so that the fill cap is either directly below the power cord, or
directly below the bypass valves on the manifold to accommodate a variety of installation variability. If you need to rotate your Pump
Reservoir, please see the "Rotating the Pump Reservoir" section of these instructions.
8
Pump
Reservoir
90 90° ° Rotation towards Power Cord Rotation towards Power Cord
Do not run the Hydraulic Pump until after hydraulic fluid has been added. Running the Hydraulic Pump without hydraulic fluid can
damage the pump.
TOOLS ANd RESOURCES REQUIREd
• Drill
• 5⁄16" Drill Bit
• 9⁄16" Box End or Socket Wrench
• Marine Grade Sealant
• Cable Ties
• 30ft/lb capacity Torque Wrench
• Awl or similar marking tool
10 | minnkotamotors.com
6
Pump Reservoir
Standard Installation Standard Installation
WARNING
• A second person to help
with installation
• Funnel
• Masking Tape
• 7/16" Drill Bit
• 5/16" Deep Well Socket or
5/16" Ratchet Wrench
Hydraulic Hydraulic
Hoses Hoses
Pump Assembly
Power Cord
NOTICE:
The orientation of the Reservoir on the pump
may affect how the Two-piece Mounting Bracket is used.
Pump
Reservoir
90 90° ° Rotation Towards Bypass Valve Rotation Towards Bypass Valve
• 1/8" Drill Bit
• 3/4" Drill Bit
• Anti-seize
• 5/32" Drill Bit
• File, sand paper, or emery board
• #2 Phillips Bit
• Tie Wraps
©2020 Johnson Outdoors Marine Electronics, Inc.
Hydraulic
7
Hoses
Control Panel Control Panel
BP
Bypass
Valves
Pressure
Wrench