MINN KOTA MKA-50 Mode D'emploi

Item /
Part # Description
Assembly
A 2991925 Bracket Stabilizer Arm Assembly (Sub)
2 2265100 Bumper Stabilizer - Bottom Bumper
4 2263624 Stabilizer Rod - Aluminum
6 2263107 Nylon Hex Nut 3/4 - 10 UNC - Jam Nut
8 2281929 Bracket - Stabilizer
10 2260221 Vinyl Cap - Top Bumper
12 2223100 Nut 5/16-18 Nylock SS
14 2263422 Bolt 5/16-18 X 1" SS - Cap Screw
16 2281700 5/16 "ID X .457 OD High Collar Lock Washer
TOOLS AND RESOURCES REQUIRED
• 1/4" Allen Wrench
• Pencil or Marker
MOUNTING CONSIDERATIONS
The Bow-Mount Stabilizer Kit is used to stabilize the
Bowguard/Steering Module and reduce bouncing when
the motor is stowed and transported. Attention to detail
is needed for successful installation. Before mounting
the Bow-Mount Stabilizer Kit, give consideration to
the following:
a. We recommend to have the MKA-50 Stabilizer Kit
installed by a qualified marine installer.
b. The MKA-50 Stabilizer Kit is intended for use on
either the Fortrex or Ultrex motor. The Stabilizer
Bracket mounts to the Bowguard on the Fortrex
and the Steering Module on the Ultrex.
c. Installation on Fortrex or Riptide SF is slightly
different than installation on Ultrex, be sure to
follow instructions appropriate to your motor.
CAUTION
Adjusting the Aluminum Rod too tightly removes the end
play needed for proper latch pin engagement and doing
so could prevent the mount from fully latching in the
stowed position. Improper latching may cause damage.
If installed correctly, the tip of the Aluminum Rod should
lift off of the boat deck about 1/4" without the mount
unlatching. Cutting the Aluminum Rod too short will
cause inadequate support of the mount. Lack of mount
support may cause damage.
©2016 Johnson Outdoors Marine Electronics, Inc.
Bow-Mount Stabilizer Kit MKA-50
Qty.
1
1
1
1 10
1
1
2
2
2
• Hack Saw
• File or Sandpaper
Fortrex
Complete Typical Installation
Ultrex
Complete Typical Installation
NOTE:
the left or right side of the Bowguard/Steering Module.
When mounting the kit onto the Ultrex, the two Nylock
Nuts (Item #12) are discarded because the bolts are
secured directly into the Steering Module. The two
Lock Washers (Item #16) are not used when installing
on the Fortrex.
12 16
14
8 6
A
• Tape Measure or Ruler
Bowguard
Steering Module
The MKA-50 Stabilizer Kit can be installed on
1862050
4 2
minnkotamotors.com | 1