MINN KOTA RAPTOR Mode D'emploi page 18

INSTALLING THE HYdRAULIC PUMP
4
ITEM(S) NEEDED
#14 X 2
h. Replace the Pump Bracket only and align the
Mounting Holes with the Pilot Holes.
i. Take two 1" Stainless Steel Screws (Item #18) and
two Serrated Washers (Item #14). Place one washer
on the end of each screw so that the crown of the
washer is facing up towards the head of the screw.
Install the Screws with drill and a #2 Phillips Bit. The
screws should pass through the Serrated Washer and
Pump Bracket and then into the Mounting Surface.
5
ITEM(S) NEEDED
#14 X 2
j. With the two Screws installed, replace the Reinforcing
Bracket onto the Pump Bracket so that the mounting
holes are again aligned.
k. Take the two remaining 1" Stainless Steel Screws
(Item #18) and two Serrated Washers (Item #14).
Place one washer on the end of each screw so that
the crown of the washer is facing up towards the head
of the screw. Install the Screws with a Drill and a #2
Phillips Bit in the overlapping holes of the Two-Piece
Mounting Bracket. The Screws should pass through
the Serrated Washer, Reinforcing Bracket and Pump
Bracket and into the Mounting Surface.
NOTICE:
If the Pump Reservoir is rotated for
installation, it will not be possible to install the
Reinforcing Bracket. To complete installation, it is
recommended to use all four Stainless Steel Screws
and Serrated Washers to secure the Pump Bracket
to the Mounting Surface.
18 | minnkotamotors.com
#18 X 2
#18 X 2
4h
Pump Bracket Pump Bracket
Pilot Holes Pilot Holes
Pilot Holes Pilot Holes
Mounting Surface Mounting Surface
5j
Reinforcing Bracket Reinforcing Bracket
Pump Bracket Pump Bracket
4i
Stainless Stainless
Steel Screw Steel Screw
Serrated Serrated
Washer Washer
Crown Crown
Up Up
Mounting Mounting
Pump Bracket Pump Bracket
Surface Surface
5k
Stainless Stainless
Steel Screw Steel Screw
Serrated Serrated
Washer Washer
Pump Bracket Pump Bracket
Crown Crown
Up Up
Reinforcing Bracket Reinforcing Bracket
©2020 Johnson Outdoors Marine Electronics, Inc.