MINN KOTA RAPTOR Mode D'emploi page 11

INSTALLATION
Installing the Raptor
1
ITEM(S) NEEDED
a. Review the Mounting Considerations to determine
if it is acceptable to complete a direct mount of the
Raptor Built-in Mounting Bracket. Move the Hydraulic
Hoses away from the bracket and out of the way
for installation. If acceptable, position the Built-in
Mounting Bracket (Item #A) at the selected location
and mark the edge of the Mounting Bracket with a
pen or similar marking tool. Mark at least 2 of the 4
edges and then set the Mounting Bracket aside.
NOTICE:
The Raptor weighs approximately
27lbs. It is recommended to have a second
person help with installation.
b. With the Raptor set aside, take the Mounting
Template (Item #34) and place it along the marked
edges. Using a level along the edge of the Mounting
Template, rotate the position of the template so that it
sits level. Use an awl or similar marking tool and mark
all four Mounting Holes. All 4 Mounting Holes are
used for the installation of the Raptor.
©2020 Johnson Outdoors Marine Electronics, Inc.
INSTALLING THE RAPTOR
#A x 1
2358830
2358830_GRAPHICS_B
1a
Hydraulic Hoses Hydraulic Hoses
Marked Edges Marked Edges
Built-in Built-in
Mounting Mounting
Bracket Bracket
Transom Transom
Marked Marked
Edges Edges
1b
Marked Marked
Edges Edges
Marked Marked
Edges Edges
Marked Marked
Transom Transom
Locations Locations
#34 x 1
Marked Locations Marked Locations
Mounting Mounting
Template Template
2358830
2358830_GR APHICS_B
minnkotamotors.com | 11