MINN KOTA RAPTOR Mode D'emploi page 35

CONTROLLING THE RAPTOR WITH THE REMOTE
Anchor
Selection
LEDs
Mode
LED
Anchor
Mode
Button
Auto
DOWN
Button
Auto Up Button
Single press to auto retract the anchor. Press and hold
to continually retract the anchor. The anchor will continue
to retract when the button is held until the button is
released. Also used to pair the Remote to a Raptor.
Auto Down Button
Double press to auto deploy the anchor. Double press
and hold the second press to continually deploy the
anchor. The anchor will continue to deploy when
the button is held until it reaches its full range of
operation or until the button is released. Also used to
pair the Remote to a Raptor.
CAUTION
Never leave the boat unattended with the Raptor as your
only boat anchor. Raptor is not intended to provide primary
anchorage. This includes operating the remote at a safe
distance. It is not recommended to leave the boat while
operating the Raptor with the remote. Doing so is at the owner's
risk. This product does not relieve you from the responsibility of
safe operation of your boat.
©2020 Johnson Outdoors Marine Electronics, Inc.
Auto UP
Button
Speed
Button/
Anchor
Selection
Button
Anchor Mode Button
Single press to display the current Anchor Mode.
While the mode is displayed, continue to single press
through the Anchor Modes to change them. This will
toggle through the Anchor Modes of Standard, Rough
Water, Soft Bottom and Auto Bottom. Standard Mode
is identified when the Mode LED
between red and green. Rough Water mode is identified
when the Mode LED
when the Mode LED
is only available on the Active Anchoring Model and is
identified by a Mode LED
from green to green and then red to red. On the Active
Anchoring Model, the Anchor Mode button will also
enable and disable Active Anchoring. Active Anchoring
is engaged and disengaged by a single press and hold.
When the Mode LED
when the Mode LED
Speed Button / Anchor
Selection Button
Single press to display the current operating speed.
While the speed is displayed, continue to single press
through the operating speed to toggle between slow,
medium and fast. The Mode LED
consecutive times at the speed that corresponds with
the selected speed. Pressing and holding the button will
toggle the remote to control either the Port, Starboard
or both anchors (when two anchors are paired in the
system). The Raptor Selection LEDs
to correspond to the anchor(s) selected. The right LED
will illuminate when the Starboard anchor is selected
and the left LED will illuminate when the Port anchor
is selected. Both the right and left LEDs
when both anchors are selected.
NOTICE:
The two Raptor remotes that come with the
Raptor from the factory are pre-paired. If the network
connection between the remotes and the anchor is
interrupted, please see the "Pairing the Raptor" section of
these instructions.
RAPTOR CONTROL
flashes
flashes red and Soft Bottom
flashes green. Auto Bottom Mode
that flashes slowly
displays green it is enabled and
displays red it is disabled.
will flash red three
will illuminate
illuminate
minnkotamotors.com | 35