MINN KOTA RAPTOR Mode D'emploi page 30

FILLING THE PUMP WITH HYdRAULIC FLUId ANd BLEEdING THE HYdRAULIC LINES
2
b. When the Pump Assembly was attached to a power
source, it beeped to indicate Power "on". To test that
there is power to the Pump Assembly, remove the
Resettable Fuse from the positive (+) white power lead
and re-insert it. When Power is restored, the LED's
will flash in a series and then the pump will beep. The
Mode LED will flash red
Pair/Maintenance LED flashes blue
will shut off and the Mode LED will flash green
When the Mode LED turns off, the pump will beep to
confirm that power is restored. The Pump Assembly is
ready to be filled with Hydraulic Fluid.
The Pump Assembly is connected to a power source during this step of the installation. Review the "Battery & Wiring Installation" section
of these instructions to become familiar with the risks involved in working with electrical currents.
3
ITEM(S) NEEDED
c. Remove the Reservoir Cap on the Pump Assembly
by turning it counter-clockwise. Set the cap aside,
making sure that it will not get dirty.
d. Place a clean Funnel or similar tool onto the
Reservoir. Notice the maximum and minimum fill
lines on the Reservoir. The Raptor Pump Reservoir is
designed to hold 1 quart of Hydraulic Fluid. Take the
Biodegradable Marine Hydraulic Fluid ISO 32 (Item
#24) and fill the Reservoir with at least half of the
quart until the Reservoir is filled to the Maximum
Fill Line.
CAUTION
Biodegradable Marine Hydraulic Fluid ISO 32
First Aid: Keep out of reach of children - do not induce
vomiting
Eye Contact: Flush affected eyes with water for at least 15
minutes.
Skin Contact: Wash any exposed skin portion thoroughly with
soap and water.
30 | minnkotamotors.com
at the same time as the
. Then the LEDs
.
CAUTION
#24 X 1
2b
Positive (+)
White Power
Lead
Resettable
Fuse
Negative (-)
Black Power
Lead
3c
Reservoir Cap
NOTICE:
If the
Reservoir Cap (Part
#2350200) becomes
lost or dirty, order
a new one online at
minnkotamotors.com.
NOTICE:
Minn Kota recommends using Biodegradable
Marine Hydraulic Fluid ISO 32 (Part #2357700.) If
additional Hydraulic Fluid is needed, order online at
minnkotamotors.com or find an equivalent ISO 32
biodegradable marine grade hydraulic fluid.
2b
PAIR/
Maintenance
Mode
UP
Button
LED
Button
DOWN
Pair/Maintenance
Button
LED
3d
Funnel
Maximum
Fill Line
Minimum
Fill Line
Biodegradable
Marine Hydraulic
Fluid ISO 32
©2020 Johnson Outdoors Marine Electronics, Inc.