MINN KOTA RAPTOR Mode D'emploi page 24

INSTALLING HYdRAULIC HOSES
8
l. Remove the black Cap on the Hydraulic Hose and
the black Cap on the "DN" Hydraulic Fitting. The
Hydraulic Hose with the black Cap will be the longer
of the two hoses that come from the Raptor.
m. Attach the Hydraulic Hose to the "DN" Hydraulic
Fitting, by turning the threaded connection on the
Hydraulic Hose onto the Hydraulic Fitting on the
pump by turning 5 to 7 times by hand. If the threads
are not freely turning, the threads are misaligned.
Lift off and try again. Hand-tighten in a clockwise
direction until seated. Then finish tightening with a
9/16" Wrench to 120 in-lbs.
NOTICE:
Do not apply anything to the ends of
the Hydraulic Hoses or the Hydraulic Fittings on
the pump.
9
n. Remove the green Cap on the Hydraulic Hose and
the green Cap on the "UP" Hydraulic Fitting. The
Hydraulic Hose with the green Cap will be the one that
has the shorter extension from the Raptor.
o. Attach the Hydraulic Hose to the "UP" Hydraulic
Fitting, by turning the threaded connection on the
Hydraulic Hose onto the Hydraulic Fitting on the
pump by turning 5 to 7 times by hand. If the threads
are not freely turning, the threads are misaligned.
Lift off and try again. Hand-tighten in a clockwise
direction until seated. Then finish tightening with a
9/16" Wrench.
24 | minnkotamotors.com
8l
Black
Caps
DOWN/deploy
"DN" Hydraulic Fitting
9n
Green
Caps
UP/retract
"UP" Hydraulic
Fitting
8m
DOWN/deploy
"DN" Hydraulic Fitting
9o
UP/retract
"UP" Hydraulic
Fitting
©2020 Johnson Outdoors Marine Electronics, Inc.