MINN KOTA RAPTOR Mode D'emploi page 16

INSTALLING THE HYdRAULIC PUMP
Installing the Hydraulic Pump
Review the mounting considerations at the beginning of the
installation. If it is necessary to rotate the Pump Assembly, refer to
the "Rotate the Pump Assembly" section of these instructions. When
ready to install the pump, follow the directions below.
1
ITEM(S) NEEDED
CAUTION
Avoid the risk of electric shock. Do not connect the
Pump Assembly to a power source before installation.
a. Take the Pump Assembly (Assembly D, E, or F) and
identify the two mounting holes on the Manifold.
The mounting holes are on the opposite side of the
pump from the brass colored Hydraulic Hose Fittings.
Position the Pump Assembly at the intended mounting
location. Review the mounting considerations and
make sure the selected location is acceptable.
b. The Two-piece Mounting Bracket consists of the
Pump Bracket (Item #20) and the Reinforcing
Bracket (Items #22). For a standard installation,
the Reinforcing Bracket sits nested on top of the
Pump Bracket with the U-shaped slots aligned.
Take the Two-piece Mounting Bracket and align
the U-shaped slots.
c. Slide the Pump Bracket and Reinforcing Bracket
together and then slide the Pump Assembly into
the bracket. The angled sides of the Reinforcing
Bracket fit along each side of the Pump Reservoir
in a standard installation. Review the mounting
considerations and position the Pump Assembly
with the Two-piece Bracket in the intended
mounting location.
NOTICE:
If the Pump Reservoir is rotated for
installation, it will not be possible to install the
Reinforcing Bracket. The position of the Pump
Bracket may vary for your installation based on
conditions outlines in the mounting considerations.
16 | minnkotamotors.com
#D, E, or F x 1
NOTICE:
Installation for your Pump Assembly may
vary from the standard installation. Review the mounting
considerations for variations in mounting.
#20 x 1
1a
Manifold Manifold
Mounting Mounting
Holes Holes
1b
Pump Assembly Pump Assembly
Mounting Holes Mounting Holes
U-shapes Slots U-shapes Slots
Pump Pump
Bracket Bracket
NOTICE:
The Pump Assembly must be mounted
vertically. If adjustments to the mounting need to be
made, rotate the position of the Two-piece bracket to
accommodate the necessity to keep the pump vertical.
#22 x 1
Pump Assembly Pump Assembly
Hydraulic Hydraulic
Hose Fitting Hose Fitting
Mounting Mounting
Surface Surface
Pump Reservoir Pump Reservoir
Mounting Mounting
Surface Surface
Reinforcing Bracket Reinforcing Bracket
©2020 Johnson Outdoors Marine Electronics, Inc.