MINN KOTA RAPTOR Mode D'emploi page 34

CONTROLLING THE RAPTOR WITH THE INdICATOR PANEL
UP
Press and hold to retract the anchor. The anchor will
continue to retract when the button is held until the
button is released.
DOWN
Press and hold to deploy the anchor. The anchor
deploys until the button is released or the anchor has
reached its full range of deployment.
Mode LED
Used to identify the different Anchor Modes. The
Mode LED
red for a period of three seconds when the anchor is
in Standard Mode. Rough Water mode is identified
when the Mode LED
Bottom when the Mode LED
The Mode LED
and then red and red when Auto Bottom is selected.
The Mode LED is used to identify Active Anchoring.
Mode LED will briefly pulse green when Active
Anchoring is enabled and the Mode LED
briefly pulse red when it is disabled. The Mode LED
will continue to pulse between green
and red while Active Anchoring is enabled and the
anchor is deployed. The Mode LED
red to identify system errors.
34 | minnkotamotors.com
RAPTOR CONTROL
UP
Button
DOWN
Button
flashes between green and
illuminates red and Soft
illuminates green.
flashes green and green
will
will also flash
PAIR/Maintenance
Mode
LED
Pair/Maintenance
LED
Pair/Maintenance LED
While the anchor is in PAIR Mode, the Pair/
Maintenance LED
Maintenance Mode, the Pair/Maintenance LED
illuminate blue.
PAIR/Maintenance Button
Single press to enter PAIR Mode. The anchor will
stay in PAIR Mode until successfully paired, the
PAIR button is pressed again to cancel it or until the
PAIR process times out after 30 seconds. Press and
hold the PAIR button to enter Maintenance Mode.
While in Maintenance Mode, the anchor motor is
disabled. To cancel Maintenance Mode, press the PAIR
button again.
Button
will flash blue. While in
©2020 Johnson Outdoors Marine Electronics, Inc.
will