MINN KOTA RAPTOR Mode D'emploi page 31

FILLING THE PUMP WITH HYdRAULIC FLUId ANd BLEEdING THE HYdRAULIC LINES
4
e. Replace the Hydraulic Cap by turning it clockwise.
f. Use the Up
Pump to cycle through the retract (up) and deploy
(down) sequence. After one to two deploy and retract
cycles, check the Reservoir to make sure that the
Hydraulic Fluid is not below the Minimum Fluid Line.
NOTICE:
During the first few cycles it is normal
for the anchor to have little movement when the Up
and Down Buttons are pressed. The Hydraulic Lines
and Cylinder must fill with Hydraulic Fluid before
normal, smooth movements will take place.
WARNING
Take care that neither you nor other persons approach
the Raptor Spike too closely while operating, neither with
body parts nor with objects. The Raptor is powerful and
may endanger or injure you or others. While the Raptor is
operating, watch out for persons and obstructions while
controlling the Raptor.
g. If the Hydraulic Fluid is below the minimum, add
more, by following the procedure above. Then cycle
the Raptor through a minimum of ten deploy and
retract cycles.
h. Once ten cycles are completed, return to filling
the Reservoir. If the Hydraulic Fluid is below the
minimum, add more, by following the procedure
above. Repeat five more retract and deploy cycles.
Finish with the Raptor in the fully retracted state.
©2020 Johnson Outdoors Marine Electronics, Inc.
and Down Buttons on the Hydraulic
4e
Reservoir
Cap
4f
UP/retract
Outer Arm Outer Arm
Trailered
Boat
4f
PAIR/
Maintenance
UP (retract)
Button
Button
Mode
LED
Pair/Maintenance
DOWN
LED
(deploy)
Button
DOWN/
deploy
Spike Spike
Inner Arm Inner Arm
UP/retract
DOWN/deploy
minnkotamotors.com | 31