MINN KOTA RAPTOR Mode D'emploi page 38

PAIRING THE RAPTOR
PAIRING TWO RAPTORS ANd PROGRAMMING THE MOUNTING LOCATION
Every Raptor comes direct from the factory with two Remotes already paired to the Raptor. When installing two Raptors, it will first be
necessary to clear all devices from both Raptor networks. To clear the pairing in each Raptor, follow the instructions in the "Clearing
Paired Remotes or Devices from the Raptor" section of the Owner's Manual. Once both Raptor networks are cleared, the Raptors can
then be paired together. The clear Raptor networks will allow the system to complete an automated process during pairing that will
designate the Port and Starboard positions of the two Raptors as installed on the boat. The process below is used to pair the Raptors
together, and to designate which side of the boat that each Raptor is installed on. Once complete, the Raptor remotes will need to
be re-paired to the dual Raptor system. Please see the "Pairing a Remote to Two Raptors" section of this manual to pair a remote.
Additional Bluetooth enabled devices may now be added to the One Boat Network such as a Humminbird fish finder, an i-Pilot or i-Pilot
Link system, and a device such as a smartphone or tablet.
1
a. Press the Pair
one of the Raptors. The PAIR/Maintenance LED will
begin to flash
on the second Raptor.
b. The Raptors are in Pairing Mode and will search for
each other for 30 seconds. If they do not Pair after
30 seconds, an error tone will sound signaling that
the Pairing has timed out. If this occurs, start the
process again.
c. If the Raptors successfully Pair, a confirmation
tone with three fast beeps will occur. At this point,
the Raptors have successfully paired, and now
need to be programmed to designate the Port or
Starboard locations. This process will automatically
begin when two Raptors have successfully paired to
each other.
2
d. The Mode Indicator LED will turn green
Raptors. On the Indicator Panel of the Starboard
Raptor, press the Up
accept the selection. The Mode LED of the Raptor
on the Port side will flash red
on both Raptors will turn off. Now the Raptors are
successfully Paired together and know their
mounted position.
38 | minnkotamotors.com
button on the Indicator Panel on
blue. Immediately follow this step
on both
button. The Raptor will
and then the LEDs
1a
UP
Mode
Button
LED
DOWN
Button
1b
PAIR/Maintenance
Button
Raptor 1
Pair/Maintenance
LED
2e
UP
Button
Raptor (Starboard)
Mode
LED
NOTICE:
When the process is complete, all remotes
that were paired to an individual Raptor will need to be
re-paired. Please see the "Pairing a remote to two Raptors"
section of this manual.
PAIR/Maintenance
Button
Pair/Maintenance
Indicator
LED
Panel
PAIR/Maintenance
Button
Raptor 2
Pair/Maintenance
LED
PAIR/Maintenance
Button
Raptor (Port)
Mode
LED
©2020 Johnson Outdoors Marine Electronics, Inc.