MINN KOTA RAPTOR Mode D'emploi page 36

NETWORK FOR A SINGLE RAPTOR
PAIRING A REMOTE TO A SINGLE RAPTOR
Every Raptor comes direct from the factory with 2 remotes already paired to the Raptor. If more remotes are paired to the Raptor than
the network allows, the Raptor will pair the new remote and remove the remote that was least recently used from the network.
1
a. Press and hold the Up
button on the Remote at the same time until
the Anchor Selection LEDs and the Mode LED on the
Remote begin to scroll
and red. Then release them.
b. Immediately press the Pair
Indicator Panel located on the Raptor Pump
Assembly. The PAIR/Maintenance LED will begin
to flash blue. The Raptor and Remote will go
into Pairing Mode for 30 seconds. If a signal with
three fast beeps occurs, the Raptor and Remote
have successfully paired. If 30 seconds pass while
in Pairing Mode and they do not successfully pair, a
chirp will sound from the Pump Assembly, signaling
that the Pairing has timed out.
c. If the Pair is unsuccessful, repeat the process.
36 | minnkotamotors.com
PAIRING THE RAPTOR
button and the Down
red, green, red
button on the
Fish Finder - Pairs to one
Humminbird HELIX or SOLIX
®
Bluetooth enable Device - Pairs
to one Bluetooth
enabled device,
(iOS or Android)
such as a tablet
or smartphone
UP
Mode
Button
LED
DOWN
Button
Anchor
Selection
LEDs
Mode
LED
i-Pilot - Pairs to one i-Pilot
or i-Pilot Link
® TM
Remotes - Pairs up to 4
remotes, including foot
switches
PAIR/Maintenance
Button
Pair/Maintenance
Indicator
LED
Panel
Raptor Remote
Auto Up/Down
Buttons & Pairing
Button
©2020 Johnson Outdoors Marine Electronics, Inc.
®