Using The Charger For The First Time; Working Display - Multiplex POWER PEAK TRIPLE 360W EQ-BID Notice D'utilisation

POWER PEAK® TRIPLE 360 W EQ-BID
5.

USING THE CHARGER FOR THE FIRST TIME

Power up the charger using a direct current of 11 to 15 V. You can also connect the char-
ger to a 12 V lead-acid battery or to the 230 V mains switched power supply unit, No. 8539.
Ensure correct polarity when connecting (red = positive/black = negative).
, the language selection menu will appear.
The menu language can then be selected from this display. The available languages can
following options available:
Language selection must be concluded by pressing the ENTER button. The start display
shown above will then appear.
5.1

WORKING DISPLAY

This display provides the user with all the necessary information during a charging or
discharging operation. The upper line of the status display shows the type of operation
(C for charging, D for discharging, F for finish and alternately C/B for balancing lithium
batteries). The charged or discharged capacity and the time elapsed since the start are
Status display
Capacity display
Actual battery
Battery type
voltage
Operating instructions
ton is pressed and held while connecting the supply
voltage. This can be
If the INC button is pressed after the connection
to the power supply and the "Cap touch sensor
" (blue LEDs light above the menu buttons) is
held down during the initialisation
also shown on the top line. The type of
Elapsed
battery (NC for nickel-cadmium battery,
time
NM for nickel-metal battery, LP for lithium-
polymer battery, Li for lithium-ion battery,
LF for lithium-ferum battery and Pb for
lead battery) is shown on the bottom line.
The display therefore shows all important
Charge /
parameters at a glance during a charging
discharge
or discharging operation.
current
8
32
# 30 8562
-