Guidelines For Parts Replacement Based On Indication Of Ch Meter; Guidelines And Precautions On Gear Oil Change Cycle - KITO ER2 Serie Manuel Du Propriétaire

Chapter 2 Inspection

Guidelines for Parts Replacement based on Indication of CH Meter

When performing the inspection, check the number of start and operating hours and utilize them for operation status control
and maintenance control.
For single speed model, check the number of start and operating hours using the CH Meter. (Refer to "Check of Operating
Hours and Number of Start (CH Meter)". (P92))
For dual speed VFD model, check the number of start and operating hours with the indicator of the VFD by the maintenance
engineer in accordance with the separate "VFD Manual".

■ Guidelines and Precautions on Gear Oil Change Cycle

Change the gear oil in accordance with the rate of loading and the operating hours.
● Change the oil at every five years even if the operating hours do not reach at the following hours.
Rate of loading
A case where the capacity is rarely applied. Usually the
Light
hoist is used with a light load.
2
A case where the capacity is applied considerably
Medium
frequently. Usually the hoist is used with a medium load.
A case where the capacity is applied considerably
Heavy
frequently. Usually the hoist is used with a heavy load.
Ultra
A case where the capacity is applied constantly.
heavy
Mandatory
Type of gear oil and its amount for one body size
Specification
Friction Clutch
Friction Clutch
with Mechanical
Brake
90
Operating hour for gear oil change
• Gear oil differs depending on the specification. Use of wrong gear oil may result in the drop of the lifted load. Be
sure to use the designated gear oil.
Failure to comply with this instruction may result in death or serious injury.
Code
ER2-001H, 001IH, 001HD, 003S, 003IS, 003SD
ER2-003H, 003IH, 005L, 005IL, 005S, 005IS,
ER2-005LD, 005SD
ER2-010L, 010IL,010SD,010LD, 020C, 020IC, 020CD
ER2-010S, 010IS
ER2-015S, 015IS, 015SD, 020L, 020IL, 020LD
ER2-020S, 020IS, 030S, 030IS
ER2-020SD, 030SD
ER2-025S, 025IS, 025SD, 050S, 050IS, 050SD
ER2-001H, 001IH, 003S, 003IS, 003SD
ER2-005L, 005IL, 005LD, 005SD
ER2-003H, 003IH, 005S, 005IS
ER2-010L, 010IL, 010LD, 010SD, 020C, 020IC, 020CD
ER2-010S, 010IS
ER2-015S, 015IS, 015SD, 020L,020IL, 020LD
ER2-020S, 020IS, 030S, 030IS
ER2-020SD, 030SD
ER2-025S, 025IS, 025SD, 050S, 050IS, 050SD
Every 120 hrs
○
○
DANGER
Gear oil amount (ml)
520
540
470
620
680
1300
1900
1800
1900
680
820
900
1050
1100
2000
2500
2300
2700
* Oil is available in 0.7L and 1.0L bottles only.
Every 240 hrs Every 360 hrs
○
○
Oil manufacturer Oil type
KITO genuine oil KITO genuine oil
KITO genuine oil KITO genuine oil