KITO ER2 Serie Manuel Du Propriétaire page 114

Chapter 3 Troubleshooting
Troubleshooting (continued)
Load Chain (continued)
Symptom
Irregular noise
3
Surface losing lust
and discolored
Breakage of the
Load Chain
114
Cause
Flaw and Replace the Load Chain with apparent
deformation of the flaw or deformation.
Load Chain surface
Hit flaw on the Load
Chain surface
Rusting and Remove rust and apply oil.
corrosion Replace the Load Chain if the rust and
corrosion is apparent.
Expiry of the Check the Load Chain and replace it if
service life exceeded the criteria. (See P69)
Remedy
Use of the Load Chain
without canceling
capsized state
Use of the Load Chain
as twisted
Hit with other object
strongly
Run-out of oil
Use of electric chain
hoist exposed to rain
Influence of sea water
and chemicals
Mechanical service life
expiry
Main factor Countermeasure
When using multi fall model
hoist, check that the Hook
is not capsized before use.
Assemble the electric
chain hoist correctly. (See
Disassembling/Assembling
Manual)
Use the electric chain hoist
carefully paying attention
not to impede with other
object.
Apply lubricant regularly.
(See P40)
Grease
application portion
Store the electric chain
hoist indoor or under the
roof when not using.
Contact KITO for the use
in special environment in
advance. Use the electric
chain hoist correctly within
the scope guaranteed by
the manufacturer.
Handle the Load Chain
correctly and perform
the appropriate control
including daily inspection
and inspection.
Load