Combination With The Trolley - KITO ER2 Serie Manuel Du Propriétaire

■ How to Use the Oil Cap (only for the Friction Clutch with mechanical brake)
An Oil Cap is packaged along with the electric chain hoist equipped with built-in Friction Clutch with mechanical brake
(option). When installing the hoist, remove the oil plug and attach the Oil Cap instead. When combining the motorized
trolley, mount the oil cap to the hoist at a position where the Oil Cap and the frame of the Trolley do not interfere. (Any
one of the following two positions)
• The gear oil for the electric chain hoist with Friction Clutch with mechanical brake is different from that for the
hoist with standard Friction Clutch. Be sure to use the genuine gear oil for the hoist with friction clutch with
mechanical brake.
Mandatory
Use of the gear oil other than the specified oil (including mixed use) will result in death or serious injury due to the drop of the
lifted load.
When using the electric chain hoist
●
To secure the draft between inside and outside of the Gear Case,
pull out the Air Vent to the position where the step of the Air Vent
can be seen.
When removing the electric chain hoist
●
To prevent the oil flow out from inclined electric chain hoist, make
sure that the Air Vent is inserted securely.

■ Combination with the Trolley

* When using the Hook suspended model (Single Unit) "Connection of Power and Power Cable", you can skip the this
section. Please proceed with Page 53.
• Adjust the rail width during assembling and install.
• Be careful for the Power Cable and Push Button Switch Set Cord are not pulled off or entangled within the area of
traveling area.
Mandatory
Failure to comply with these instructions may result in death or serious injury.
DANGER
Oil Cap
DANGER
Air Vent
Packing
(to be continued)
41
1 1