KITO ER2 Serie Manuel Du Propriétaire page 147

• When any abnormality is observed during inspection, stop the use of electric
chain hoist, indicate "FAILURE", and contact the maintenance engineer or
KITO for repair.
Mandatory
Use of the product with abnormality may result in death or serious injury.
■ Manual Trolley TS2 (TSG/TSP) Periodic Inspection
■Check result : ○ Good, △ To be replaced (adjusted) next inspection, × Bad, Needs replacement (adjustment)
Category Check item
Wheel
Lifting shaft
Suspender
Rail surface
Deformation, abrasion
Rail fixing bolt
Stopper
Traveling operation with
a capacity
Operational check Visual inspection/
inspection by
measurement
Traveling operation with
a capacity
Strange noise Visual inspection/
inspection by
measurement
Executed by Inspector
Checked by Maintenance Engineer
DANGER
Check method
Visual inspection/ • To have no apparent deformation and damage
inspection by • Abrasion of outer diameter to be less than limit
measurement value
Visual inspection/ • To have no apparent deformation and damage
inspection by • Abrasion of outer diameter to be less than limit
measurement value
Visual inspection/ • To have no apparent deformation and damage
inspection by • Abrasion of outer diameter to be less than limit
measurement value
• To have no attachment of paint, oil and foreign
Visual inspection matter
• To have no dust and powder due to abrasion
Visual inspection/ • To have no deformation of beam flange such as
inspection by twist and shear drop
measurement • To have no exceeding abrasion of rail surface
To be mounted securely without looseness and
Visual inspection
come-off
To be mounted securely without looseness and
Visual inspection
come-off at the rail end
Perform inspection of the items on function/
performance of daily inspection with no load, and
then perform the inspection of the same items with
a capacity.
Perform inspection of the items on function/
performance of daily inspection with no load, and
then perform the inspection of the same items with
a capacity.
Criteria
/
NOTE
Decide the check items
appropriate to the
environment and operating
conditions of the customer.
Inspection date/result
/ / / / /
A
147