KITO ER2 Serie Manuel Du Propriétaire page 42

Chapter 1 Handling the Product
Assembling (continued)
■Combining with the Motorized Trolley
Prohibited
■ Parts replacement of the electric chain hoist
The Suspender is attached to the electric chain hoist at shipping.
1
Refer to the following figure to remove the Top Hook and replace the Suspender with the Suspender T.
● Replacing the Top Hook of Body size ER2-B/C/D/E
1) Remove the Shaft Retainer Clip using plier.
2) Remove the Socket Bolt from the Shaft
Retainer, and remove the Shaft Retainer.
3) Remove two Connection Shafts.
4) Remove the Top Hook and replace it with the
Suspender T.
5) Insert two Connection Shafts into the hole of
the Body size.
6) Mount the Shaft Retainer with Socket Bolt.
Replacing the Top Hook of Body size ER2-F
●
1) Remove four Socket Bolts and remove the
Controller Cover.
2) Remove pan head screws of the Connection
Shaft and the Fixing Shaft (two screws each),
and remove the Shaft Retainer.
3) Pinch the respective upper ends of the
Connection Shaft and the Fixing Shaft and
pull out them.
4) Remove the Top Hook and replace it with the
Suspender T.
5) Insert the Connection Shaft and Fixing Shaft
into the mounting hole.
6) Fix the Shaft Retainer of the Connection
Shaft and the Fixing Shaft with pan head
screws (two screws each).
7) Mount the Controller Cover with four pan
head screws.
42
• When using ER2 series electric chain hoist combined with our old type product, specification needs to be
changed. Contact your nearest dealer or KITO.
CAUTION
For Double Chain Type
Suspender T
Shaft Retainer
Clip
For Double Chain Type
Bracing Shaft
O ring
Shaft Retainer
Pan Head
Screw
Pan Head Screw
Socket Bolt
Top Hook
Connection
Shaft
Shaft
Retainer
Socket
Bolt
Top Hook
Suspender T
Connection
Shaft
O ring
Panel
Shaft Retainer
Controller Cover