KITO ER2 Serie Manuel Du Propriétaire page 60

Chapter 1 Handling the Product
Installation (continued)
■ Power Cable Layout for Motorized/Manual trolley type
• In the standard specification the Suspender is provided. T-shape Suspender and angle type Suspender are also
available as optional parts. T-shape Suspender can be applicable to curved rail, however, the application method differs
depending on the condition such as radius of curvature. In such case, contact KITO.
1) Mount the wire support bar at the both ends
of the rail.
1
2) Tie the Messenger Wire passed through the
Cable Hanger to the Wire Support Bar with
two Wire Bolts.
• The recommended mounting interval of the Cable
Hangers is 1.5 m to 2 m.
• Use steel wire of 3 to 6 mm in diameter for the
Messenger Wire.
3) Loosen two pan head screws and remove
the end clip of the wire guide.
4) Pass the Messenger Wire through the
groove of the messenger guide. Mount the
end clip with two pan head screws.
• The dimension A between the side face of the rail
and the groove of the wire guide must be same as
that of mounting hole of the Wire support bar for the
Messenger Wire and the side face of the rail.
5) Fix the Power Cable to the Cable Hanger.
6) Mount the Cable Support to the Cable
Support Arm.
7) Insert the Power Cable into the Connection
Box of MR2 and connect it to the terminal
panel.
• Connect wires correctly according to the wiring
diagram affixed on the Connection Box.
60
Rail
Wire support bar
A
Cable Hanger
Wire support bar
Wire bolt
Messenger Wire
Motor Beam Connection Box
A
Connection Box
Power Cable
Cable support arm
Pan head screw
Wire Guide
Messenger Wire
Cable hanger