KITO ER2 Serie Manuel Du Propriétaire page 50

Chapter 1 Handling the Product
Assembling (continued)
■ Combination of the Electric Chain Hoist and the Manual Trolley
Mandatory
125 kg~2.5 t
●
1) After setting the Suspension Shaft with
1
Spacers, insert it into Frame G or Frame S
and fix it with a Shaft Stopper Pin and a Split
Pin.
• Insert the Shaft Stopper Pin in the direction that the
split pin comes to the right when viewed from the side
of the Frame G or Frame S.
• Open the both ends of the Split Pin by 70˚ or more.
2) Set the Suspension Shaft with a Thin Spacer,
Thick Spacer and Fixing Spacer.
3) Set the Suspender with the Suspension Shaft.
4) Set the Suspension Shaft with another Thin
Spacer, Thick Spacer and Fixing Spacer. Then
insert the Suspension Shaft into the Frame
SN.
• Adjust the Spacers in accordance with the rail width.
(Refer to "Checking the Number of the Assembled
Adjusting Spacers and Their Positions" (P48) for the
number of Spacers.)
5) Set the Suspension Shaft with a Thick Spacer. Fix it
with a Shaft Stopper Pin and a split pin.
• Insert the Shaft Stopper Pin in the direction that the
split pin comes to the right when viewed from the front
side of the Frame SN.
• Open the both ends of the Split Pin by 70˚ or more.
6) Mount the Suspender to the Connection Yoke
with a Yoke Bolt, a slotted nut and a split pin.
Note:
When connecting the Suspender and
Connection Yoke, the insertion direction of the
Yoke Bolt is different according to the types of
the manual trolleys to connect with. (See the
figures in the right.)
Split pin
70° or more
Bending the split pin
50
• Use new split pins. After insertion, bend the pin securely at its both ends.
Use of old split pins may result in death or serious injury due to drop.
Shaft Stopper Pin
Orientation of Shaft Stopper Pin
DANGER
Split pin
Shaft Stopper
Pin
Thin spacer
(t=3.2)
Hand
Chain
Suspender
Split pin
Suspender of
the Main Unit
Slotted nut
(For Plain Trolley)
*Use connection yoke rubber when the beam width in not more
than in not more than 98mm by combining geared trolley TSG.
Frame S
Frame G
Thin spacer
Thick spacer
Fixing spacer
Suspension Shaft
Fixing spacer
Thick spacer
Frame SN
Thin spacer
Split pin
Yoke Bolt
Thick spacer
Thin spacer (t=3.2)
Shaft Stopper Pin
*Connection yoke
rubber (only 1t)
Use beam width not
more than 98mm
(For Geared Trolley)