KITO ER2 Serie Manuel Du Propriétaire page 58

Chapter 1 Handling the Product
Installation (continued)
■ Installing the Trolley Combined Model
■Mounting the Hoist to the Travel Rail
1) Make sure that the dimensions of the Trolley
Frame satisfy the size of the rail to which the
trolley is installed.
2) Make sure that the rail is set to a level.
3) Install the electric chain hoist combined with
1
the trolley to the rail from its one end
When the gap between the rail end the wall of the housing is scarce
●
Mandatory
1) Assemble the Trolley temporarily using the
hole B of the Suspension Shaft and install
the electric chain hoist from the bottom side
of the Travel Rail.
2) Set the wheel at G side of the Trolley Frame
on the running face of the Travel Rail. Then
push the Frame S into the Frame G.
3) Insert the Shaft Stopper Pin into the Hole A
of the Suspension Shaft. Then mount a split
pin securely.
58
• Securely support the electric chain hoist Mode ER2 not to tilt.
Failure to comply with this instruction causes bodily injury or loss of property.
CAUTION
Frame G
Lifting Shaft
Sling
Sling
Frame S
Hole B
Hole A