KITO ER2 Serie Manuel Du Propriétaire page 35

■ Precautions After Work
• Do not store the electric chain hoist at a state of over lifting or over lowering.
Failure to comply with these instructions causes bodily injury or loss of property.
Prohibited
• Store the electric chain hoist with power off.
• Indicate "FAILURE" on the electric chain hoist that needs repair not to be used.
• Wipe off dust and waterdrop, apply oil at the neck of the Hook and the Load Chain and store the hoist.
Mandatory
• Remove the stain, attached foreign matter and waterdrop from the parts such as the Limit Switch and the Chain
Container that is scratched by the Load Chain or stored it.
• When the electric chain hoist is installed outdoor, cover it with rain cover or roof after application of rust proof
process.
Failure to comply with these instructions causes bodily injury or loss of property.
• Clean the push buttons always not to allow the dust and sands attach.
• When storing the electric chain hoist for a long period, it is effective to prevent rusting to operate it at a certain period without
load.
• When putting the electric chain hoist on a floor, remove the Chain Container.
Otherwise the Chain Container may deform or be damaged.
• When not using the electric chain hoist, wind up the Bottom Hook to the height not to hinder persons passing by or other work.
• Decide the place to store the electric chain hoist in advance. It is recommended to hang the push button set on the pillar.
CAUTION
NOTE
1 1
35